- 您現在的位置：買賣IC網 > PDF目錄354437 > MC33984 (Motorola, Inc.) Dual Intelligent High-Current Self-Protected Silicon High-Side Switch (4.0 mз) PDF資料下載
參數資料
| 型號： | MC33984 |
| 廠商： | Motorola, Inc. |
| 英文描述： | Dual Intelligent High-Current Self-Protected Silicon High-Side Switch (4.0 mз) |
| 中文描述： | 雙智能大電流的自我保護硅高邊開關（4.0mз） |
| 文件頁數： | 13/28頁 |
| 文件大小： | 492K |
| 代理商： | MC33984 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
33984
MOTOROLA ANALOG INTEGRATED CIRCUIT DEVICE DATA
20
Previous Address SOA[2:0]=000
If the previous three MSBs are 000, bits OD6:OD0 will reflect
the current state of the Fault register (FLTR) corresponding to
the output previously selected with the bit OD7 (Table 9).
Previous Address SOA[2:0]=001
Data in bits OD1:OD0 contain CSNS0 EN and IN0_SPI
programmed bits, respectively. Data in bits OD3:OD2 contain
CSNS0 EN and IN0_SPI programmed bits, respectively.
Previous Address SOA[2:0]=010
The data in bit OD3 contain the programmed overcurrent
high detection level (refer to Table 4, page 17), and the data in
bits OD2:OD0 contain the programmed overcurrent low
detection levels (refer to Table 3, page 17).
Previous Address SOA[2:0]=011
Data returned in bits OD1 and OD0 are current values for the
overcurrent fault blanking time, illustrated in Table 5, page 18.
Bit OD2 reports if the overcurrent detection timeout feature is
active. OD3 reports if the open load circuitry is active.
Previous Address SOA[2:0]=100
The returned data contain the programmed values in the
DICR.
Previous Address SOA[2:0]=101
SOA3 = 0. The returned data contain the programmed
values in the OSDR. Bit OD3 (FSM_HS0) reflects the
state of the output HS0 in the Fail-Safe mode after a
watchdog timeout occurs.
SOA3 = 1. The returned data contain the programmed
values in the WDR. Bit OD2 (WDTO) reflects the status of
the watchdog circuitry. If WDTO bit is logic [1], the
watchdog has timed out and the device is in Fail-Safe
mode. If WDTO is logic [0], the device is in Normal mode
(assuming the device is powered and not in Sleep mode),
with the watchdog either enabled or disabled. Bit OD3
(FSM_HS1) reflects the state of the output HS1 in the Fail-
Safe mode after a watchdog timeout occurs.
Previous Address SOA[2:0] =110
SOA3 = 0. OD3:OD0 return the state of the IN1, IN0, FSI,
and WAKE terminals, respectively (Table 10).
SOA3 = 1. The returned data contain the programmed
values in the UOVR. Bit OD1 reflects the state of the
undervoltage protection and bit OD0 reflects the state of
Previous Address SOA[2:0]=111
Null Data. No previous register Read Back command
received, so bits OD2:OD0 are null, or 000.
Table 9. Fault Register
OD7
OD6
OD5
OD4
OD3
OD2
OD1
OD0
s
OTF
OCHFs OCLFs
OLFs
UVF
OVF FAULTs
OD7 (s) = Selection of output: logic [0] = HS0, logic [1] = HS1.
OD6 (OTF) = Overtemperature Flag.
OD5 (OCHFs) = Overcurrent High Flag. (This fault is latched.)
OD4 (OCLFs) = Overcurrent Low Flag. (This fault is latched.)
OD3 (OLFs) = Open Load Flag.
OD2 (UVF) = Undervoltage Flag. (This fault is latched or not latched.)
OD1 (OVF) = Overvoltage Flag.
OD0 (FAULTs) = This flag reports a fault and is reset by a read
operation.
Note
The FS terminal reports a fault. For latched faults, this terminal
is reset by a new Switch ON command (via SPI or direct input IN).
Table 10. Terminal Register
OD3
OD2
OD1
OD0
IN1 Terminal
IN0 Terminal
FSI Terminal
WAKE Terminal
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相關PDF資料 |
PDF描述 |
|---|---|
| MC33689 | Single Output LDO, 400mA, Fixed(2.85V), Low Noise, Fast Transient Response 8-MSOP -40 to 85 |
| MC33689DWB | Single Output LDO, 400mA, Fixed(2.85V), Low Noise, Fast Transient Response 8-MSOP -40 to 85 |
| MC100LVEL39 | Replaced by TPS2051B : 0.7A, 2.7-5.5V Single Hi-Side MOSFET, Fault Report, Act-High Enable 8-SOIC 0 to 85 |
| MC100LVEL39DW | Single, Current-Limited, Power-Distribution Switch 5-SOT-23 -40 to 85 |
| MC74LVQ08D | Enhanced Low Input (2.25V-5.5V) up to 1MHz Frequency, Sync. Buck Controller, source only 16-HTSSOP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC33984BPNA | 功能描述:電源開關 IC - 配電 SPD4 RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MC33984BPNAR2 | 功能描述:電源開關 IC - 配電 SPD4 RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MC33984CHFK | 功能描述:電源開關 IC - 配電 Dual 4mOhms smart RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MC33984CHFKR2 | 功能描述:電源開關 IC - 配電 Dual 4mOhms smart RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MC33984PNA | 制造商:Freescale Semiconductor 功能描述:POWER SWITCH HI SIDE 30A 16-PIN QFN - Trays |
發布緊急采購，3分鐘左右您將得到回復。