參數資料
型號： MC68HC05P3
廠商： Motorola, Inc.
元件分類： DC/DC變換器
英文描述： RS3-S_D(Z) Series - Econoline Regulated DC-DC Converters; Input Voltage (Vdc): 12V; Output Voltage (Vdc): 05V; Power: 3W; 2:1 and 3:1 Wide Input Voltage Ranges; 1kVDC, 2kVDC & 3kVDC Isolation; UL94V-0 Package Material; Continuous Short Circuit Protection; Low Ripple and Noise; Remote On/Off Control; Efficiency to 83%
中文描述： 微機單位的16位可編程定時器
文件頁數： 48/96頁
文件大?。?/td> 3045K
代理商： MC68HC05P3
Freescale
7-2
MC68HC05SR3
ANALOG TO DIGITAL CONVERTER
7
7.1
ADC Operation
As shown in Figure 7-1, the ADC consists of an analog multiplexer, an 8-bit digital to analog
capacitor array, a comparator and a successive approximation register (SAR).
There are eight options that can be selected by the multiplexer; the AN0 to AN3 input pins, VRH,
VRL, (VRH+VRL)/4, or (VRH+VRL)/2. Selection is done via the CHx bits in the ADC Status and
Control Register. AN0 to AN3 are input points for ADC conversion operations; the others are
reference points which can be used for test purposes. The converter uses VRH and VRL as
reference voltages. An input voltage equal to or greater than VRH converts to $FF. An input voltage
equal to or less than VRL, but greater than VSS, converts to $00. Maximum and minimum ratings
must not be exceeded. Each analog input source should use VRH as the supply voltage and should
be referenced to VRL for the ratiometric conversions. To maintain full accuracy of the ADC, the
following should be noted:
1) VRH should be equal to or less than VCC;
2) VRL should be equal to or greater than VSS but less than maximum
specifications; and
3) VRH–VRL should be equal to or greater than 4 Volts.
The ADC reference inputs (VRH and VRL) are applied to a precision internal digital to analog
converter. Control logic drives this D/A converter and the analog output is successively compared
with the selected analog input sampled at the beginning of the conversion. The conversion is
monotonic with no missing codes.
The result of each successive comparison is stored in the successive approximation register
(SAR) and, when the conversion is complete, the contents of the SAR are transferred to the
read-only ADC Data Register ($0F), and the conversion complete flag, COCO, is set in the
ADC Status and Control Register ($0E).
Warning: Any write to the ADC Status and Control Register will abort the current conversion,
reset the conversion complete flag (COCO) and a new conversion starts on the
selected channel.
At power-on or external reset, both the ADRC and ADON bits are cleared, thus the ADC is
disabled.
TPG
50
05SR3.Book Page 2 Thursday, August 4, 2005 1:08 PM
相關PDF資料
PDF描述
MC78L05 5.0 AMP POSITIVE VOLTAGE REGULATOR
MC100EP16D Differential Receiver
MC33984 Dual Intelligent High-Current Self-Protected Silicon High-Side Switch (4.0 mз)
MC33689 Single Output LDO, 400mA, Fixed(2.85V), Low Noise, Fast Transient Response 8-MSOP -40 to 85
MC33689DWB Single Output LDO, 400mA, Fixed(2.85V), Low Noise, Fast Transient Response 8-MSOP -40 to 85
相關代理商/技術參數
參數描述
MC68HC05P4 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNIT
MC68HC05P4A 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers
MC68HC05P4DW 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNIT
MC68HC05P4P 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNIT
MC68HC05P6 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNIT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*